Labels:text | font | black and white | screenshot | document OCR: UPDATING TO JANUS 2.1 BETA 2 FROM A PREVIOUS VERSION OF JANUS - Remove commands such as : run sys: pc/pcdisk run sys : pc/amouse run sys : pc/services/dosserv run sys : pc/services/timeserv run sys: pc/services/autoload from your Startup-Sequence, PCDisk and AMouse have been replaced by DOSServ and MouseServ. DOSServ, MouseServ, and TimeServ are now automatically run when needed, AutoLoad is now automatically run by Janus . library. You may leave any PCWindow commands in place if you want PCWindow to start every time your Amiga is booted. - If the PC side has a (real or fake) hard drive: - Remove any JANUS UTILITY commands such as ATIME, JLINK, AMOUSE, AREAD, Or AWRITE from your MS-DOS AUTOEXEC.BAT file. You may just insert "REM " in front of them (to comment them out) so you can put them back later. - Remove JDISK. SYS from your MS-DOS CONFIG. SYS file. These steps are to prevent confusion that can occur when the PC tries to run different versions of Janus software than the Amiga. Perform STEP 1 below (installs new Amiga-side Janus software) . - If the PC side has a (real or fake) hard drive: NOTE: The MS-DOS INSTALL program copies all DOS commands to C:\DOS. It will also place new COMMAND. COM, CONFIG. SYS, and AUTOEXEC. BAT files in the root of your C: drive. You may wish to make backup copies of your AUTOEXEC. BAT and CONFIG. SYS files so you can merge your changes back into the new ones. NOTE : The MS-DOS INSTALL program will need a blank floppy of the same type as the MS-DOS INSTALL disk. Insert the MS-DOS 4. 01 INSTALL disk into the Bridgeboard's A: floppy drive. - Reboot the Bridgeboard (press CTRL+ALT+DEL) . - Follow the directions on the screen. See the MS-DOS 4.01 manual for further information. - Merge your old AUTOEXEC. BAT and CONFIG. SYS changes into the new AUTOEXEC. BAT and CONFIG. SYS files. - If the PC side runs from floppies only: - Perform STEP 2C below.
(.png)
